Landscape lighting is a commonly performed project by houston landscape lighting experts, home improvement professionals, and homeowners. Low voltage landscape lighting is generally the most accessible lighting type to install. Low voltage is considered 12 volt AC. This voltage is ideal for landscape lights and easy to install. All that is required to finish the job is a rough layout of where you want to put your lights, the light fixtures themselves, a timer, and a transformer.

The tools required to perform the installation are an electric drill, a pair of lineman’s pliers, a trenching machine, and a screwdriver. The landscape lights available at retail outlets for purchase are almost always easy to put together. Most lighting systems come with fixtures that the installer snaps together. Lighting systems are commonly found in packages that also include the connectors required for the assembly as well as a transformer.

If you prefer to buy the pieces separately, that can be done with the help of a retail clerk in places like Home Depot, Lowe’s, or a mom and pop hardware shop. To buy the lighting parts separately can allow for more customization.

Lighting Installation Process

First you need to set up the wiring for the transformer. The transformer will bring the voltage down to 12 volts from 120 volts. Start by taking the cable for the lights and attaching it. The only thing you need to do here is to screw the wires into place.

Now you can move on to step two, which is hanging the transformer. The transformer needs to be hanged on a wall next to the GFCI outlet.

In step three, you will assemble the lights. You will find that your landscape lights will require assembly. Don’t worry, and the construction is usually little more than snapping some sockets into place. You need to pay attention to the manufacturer’s manual thoroughly.

Step four is the placing of your lights. Put the lights where you desire and then connect the cable from light to light.

Step five is to connect the lights. To do this, you will probably have to take a connector and snap each side of it together around the cable.

The sixth step is digging a trench to lay the wire down in. The trench can be relatively shallow. Lay the cables down in the channel. Do not bury the cable at this time.

Step seven is setting the timer. Plug the transformer into an outdoor receptacle and then set the timer. Cover the outlet with a plastic cover for safety purposes.

Step eight is to test the lights. If your lights turn on, then you have finished installing landscape lighting on your property.